Hey! Question, I figured out how to record different chords through my key step pro by way of your YouTube videos. Still a little bit confused on how to cycle through them with just CV. I would really like to have the key step out of the process once the chords are in. I have Pams and a Erica Synths Drum Sequencer that I'm trying to send CV from and it just seems to repeat the same chord and occasionally switch to another one. In your video you cycle through them with your sequencer. Wondering if you could give me a little more detail on how to do that. Couldn't figure it out from watching your videos. Thanks!
top of page
bottom of page
I calculated what I think are the theoretical optimal voltages to use to select chords. With testing, these seem to work without fail.
0.313
0.938
1.563
2.188
2.813
3.437
4.062
4.687
These are the midpoints of the 8 "bands" of voltages obtained by dividing 0-5V into 8 equal parts.
Hello, can you provide the required voltage for each chord ? or maybe just tell me if the following measures are right :
Chord 1 : 0.62V Chord 2 : 1.25V Chord 3 : 1.87V Chord 4 : 2.50V Chord 5 : 3.12V Chord 6 : 3.75V Chord 7 : 4.37V Chord 8 : 5V Thank you!
The 8 chords are selectable over a 0-5v range so you will need to send a wide range of voltages to access all 8 chords. Also it is not advisable to change chord at the same time as sending a gate since the intended voltage will be sampled whilst it is still changing although poly cinematic does a pretty good job to mitigate this. Currently there is no way to clear to chord bank.
Also is there a way to clear the Chord bank?