The issue still persists. Somethimes it gets okay - bpth channels works fine and somethimes the right one getss noisy and go at really low levels. This look like cold joint or something like that. Assuming that maybe will need soldering and additional measurements and it can be performed by you in UK. For now i will use in only in L (as mono)

got it! will check it later! thanks

and waht is the procedure of resetting the daisy board, is it written in the manual?

non cv's are connected exept of clock sync, but will do factory reset if the issue still persiste will notify again

This Version has been installed already and an issue has been noted: the module has switched off the sound it has been stated about four times during use. It occurred once when switching from peak to comb modes, and three times while attempting to record tweaks and play them on a loop, assuming that the issue appears only on loop mode! During these instances, impulse spikes caused the module to stop producing sound, requiring a power restart to resume functionality. I have noticed that have to switch again from loop to play mode when restarting because when restarting with loop mode switched on still there's no sound, so I turned back on play mode and restarted again the power in order to resume playing.